Fisher-Price BARBIE BEACH RANGER 78477 Owner's Manual & Assembly Instructions page 20

32
Sport Bar
• Position the sport bar upright, as shown.
• Fit and hold the front and back halves of the KC
rack against the sport bar. Make sure the two KC
rack halves are aligned, and that the screw holes in the
KC light rack are aligned with the screw holes in the
TM
canopy and the sport bar.
• Snap the tabs on the front half of the KC
the slots below the light housings on the rear half of the
KC TM light rack.
• Insert two #6 x1 1 / " screws through the holes in the back
2
of the KC TM light rack, through the sport bar, and into the
front half of the KC light rack.
TM
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
33
• Align the tabs on the inside of a light cover with
the slots in one of the light housings on the
KC TM light rack.
• Push firmly on the light cover to snap it to the
light housing.
• Repeat this procedure on the other side of the
KC TM light rack to assemble the other light.
Assembly
KC TM Light
Rack - Back Half
Tabs
KC Light
TM
Rack - Front Half
TM light
TM light
TM light rack into
KC TM Light Covers
20
34
PUSH
HERE
Side
Fender
PULL HERE
• Fit the sport bar and sport bar support legs into the holes
in the vehicle body.
• Push down firmly on a sport bar side leg while pulling
up on the side fender to fit the sport bar into the
vehicle body.
• Repeat this procedure on the other side of the
vehicle body.
• Insert a 1 1 / " x 1 / " machine screw into the hole closest to
2 4
the front of the vehicle in the underside of the rear wheel
well, through the vehicle body and into the end of the
sport bar.
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten.
• Repeat this procedure on the other side of the
vehicle body.
35
Rear Bumper
Tabs
Lower Rail
• Face the rear of the vehicle.
• Fit the lower rail on the rear bumper over the rear
bumper support.
• Gently bend the tabs at the bottom of the rear bumper
under the vehicle.
Sport Bar
Rear Bumper
Support