Fisher-Price BARBIE BEACH RANGER 78477 Owner's Manual & Assembly Instructions page 18

24
Short Seat
Belt Strap
End
T-Loops
Seat
• Turn the seat upside down.
• Insert the fastener end of a short seat belt strap through
the slot near the outer edge of the seat. Make sure the
side of the seat belt with the fastener faces the outer
edge of the seat.
• Pull the short seat belt strap completely through the
slot until the last T-loop at the opposite end of the belt
catches against the slot. You will pull one T-loop through
the slot.
• Repeat this procedure to assemble the other short seat
belt strap.
25
T-Loop
Fastener
• Insert each end of the long seat belt strap through a slot
in the center of the seat. Make sure the fasteners face
the outer edge of the seat.
• Pull each side of the long seat belt strap evenly through
the slots. Make sure to pull each T-loop through a slot.
• Turn the seat upright.
T-Loop (Pull through slot)
Fastener
End
Slot
Long Seat Belt Strap
Assembly
26
Seat Back Tabs
3
Slot
• With the seat at an angle, insert the tabs on the front
edge of the seat into the slots in the foot-well wall
• Push down firmly on the edge of the seat above each
tab to snap the tabs into the slots
• Rotate the back of the seat down
back tabs into the slots in the vehicle body. Push down
firmly on the seat back.
27
• Insert a #8 x 1" screw into the rear of seat as shown.
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten.
18
Seat
Tabs
PUSH
HERE
2
1
.
2
to snap the seat
3
#8 x 1" Screw
.
1