Remote Start Features; Remote Starting; Shut Down; Quick Stop - Scytek electronic 2000RS Product Manual

Vehicle security system with remote start

Hide thumbs

Table Of Contents

Table of Contents

Remote Starting

To Remote Start the System:

1. Be sure the system is not in Valet Mode.

2. Press and hold Button 4 for three seconds.

· The parking lights will flash 4 times and turn on.

· The siren/horn will chirp/honk 4 times. ( if enabled, see page 23 branch 9 )

· The engine will start and run for the duration of its programmed Run Time.**

· The heater or air conditioner will turn on (if turned on prior to exiting the vehicle).

**If the engine fails to start on the first attempt, it will repeat the starting procedure 2 more times. If the vehicle

fails to start after a total of 3 times the parking lights will flash 4 times and the doors will lock (if installed).

Turn on the ignition and press the brake pedal to disengage the remote start feature and drive the vehicle.

Shut Down

When the the Remote Start feature is active, any of the following actions will shut down the engine:

1. Pressing Button 4.

· After the engine shuts down the doors will lock

2. Pressing the Brake Pedal.

3. Opening the Hood.

4. Remote Start Time-Out (completion of the timed run cycle).

Quick Stop

The Quick Stop Feature allows you to exit the vehicle while keeping the engine running for quick stops.

To leave the vehicle running:

2. While the engine is running push the Remote Start button on the Remote Transmitter.

· The parking lights will turn On.

4. Remove the key from the ignition switch.

5. You may now exit the vehicle and lock the doors manually or by using the Remote Transmitter

To resume control of the vehicle:

1. Unlock the doors manually or by pressing the Disarm/Unlock Button on the Remote Transmitter.

2. Turn on the ignition.

3. Press the Brake Pedal to disengaged the remote start.

· The parking lights will turn Off.