Advertisement
STEP 2 - Ant|-TiD Bracket Installstion Opti_ls
STEP 3 - Ranqe Installation
A. Wood Construction:
A. A Jenn-Air range may be installed by one person.
1, Floor: Locate the center of the two holes identified
in figure 5 as "HOLES FOR FLOOR." Drifta 1/8"
B. Align the range to its designated location and slide it
(3 mm) pilot hole in the center of each hole (a nail
back into position, Note: A minimum clearance of 1/4"
or awl may be used if a drill is not available).
(6 mm) is required between the range and the leveling
Secure the ANTi-TIP bracket to the floor with the
foot that will engage the ANTI-TIP bracket, see figure
two screws provided. Proceed to STEP 3,
6.
2. Wall: Locate the center of the two holes identified
in figure 5 as "HOLES FOR WALL." Drill an
C. All Jenn-Air ranges have a non lift-up top,
angled 1/8" (3 mm) pilot hole in the center of each
hole as shown in figure 6. (A nail or awl may be
D. For SAFETY CONSIDERATIONS as well as optimum
used if a drill is not available). Secure the
performance adjust the range so that it is level. This
ANTI-TIP bracket to the wall with the two screws
may be checked by placing a spirit level or a large
provided as shown in figure 6. Proceed to STEP
pan of water on the cooktop or the oven rack. If an
3.
adjustment is required pull the range forward, tip the
B. Cement or Concrete Construction:
range and rotate the leveling feet as required.
1. Suitable screws for concrete construction can be
E. To check the range for proper installation of the
obtained at the hardware store. Drill the required
anti-tip bracket: Use a flashlight and look underneath
size hole for the hardware obtained into the
concrete at the center of the holes identified in
the bottom of the range to see that one of the rear
figure 5 as "HOLES FOR FLOOR", Secure the
leveling feet is engaged in the bracket slot.
ANTI-TIP bracket to the floor. Proceed to STEP 3.
F. Proceed with the remainder of the installation
instructions provided with the range.
NOTE:
USE A MINIMUM
OF (2)
SCREWS
TO INSTALL
ANTI-TIP
BRACKET
TO THE WALL OR FLOOR.
/-ANTI-TIP
_
/
BRACKET
SCREWS
MUST
_]-_/f_
ENTER
WOOD
_
SCREW
BRACKET
......
0.METAL.
\
NIl/
TO WALL
_)_)M
7
,,
\
_J_
/
SLIDE
IN
m
/
F 'j/4-
WA,L P LATE-,, \ t IM/
TO SECUREtt
/
X
\
K:x]lll/
_
_
!
/
MIN.
K//////////////////////////////J
/_TJ
g215-117
FIGURE 6
-6-
Advertisement
