Modifying The Note Dynamics (Change Velocity); Modifying The Note Durations (Change Gate Time) - Roland Workstation GW-8 Supplementary Manual

Modifying the Note Dynamics
(Change Velocity)
This function modifies the dynamics of the specified region.
1. In the "Style Edit Menu," select "7. Change Velocity" and
press [ENTER].
The STYLE EDIT CHANGE VELOCITY screen will appear.
2. Use [ ] [ ] [ ] [
parameter you want to change, and use the VALUE dial to
make the desired setting.
Parameter Value
ADrum,
ABass,
PART
Acc1–6,
ALL
Maj, min,
CHORD
7th
INT1–4,
MAIN1–4,
DIVISION
FILL1–4,
END1–4
From
0001: 01:
(MEAS:
000–
BEAT: TICK)
To (MEAS: 0001: 01:
BEAT: TICK)
000–
Bias -99–99
Magnify 0–200%
] to move the cursor to the
Explanation
Selects the Style part whose
velocity is to be modified.
Selects the chord.
Selects the division.
Specifies the beginning of the
region whose velocity is to be
modified.
Specifies the end of the region
whose velocity is to be modified.
Specifies the amount by which
the velocity is to be modified.
Allows you to make the velocity
more uniform, or to decrease or
increase the dynamics.
If Magnify is set near 0%, the
velocity will be adjusted toward
64, and the Bias value will be
added to each velocity value.
This allows you to make the
velocity more consistent while
adjusting it as desired.
If Magnify is set to 101% or
higher, velocities greater than
64 will be increased while
velocities below 64 will be
decreased, increasing the
dynamics.
If Magnify is set to 100%, the
velocity will not change.
Parameter Value
C–(Note
Note
Range
Range Min
Max value)
(Note
Note
Range Min
Range Max
value)–G9
3. Select "EXECUTE" and then press [ENTER].
It is not possible to restore the data to its original state after
executing this operation.
Modifying the Note Durations
(Change Gate Time)
This function modifies the durations of the notes in the
specified region.
1. In the "Style Edit Menu," select "8. Change Gate Time"
and press [ENTER].
The STYLE EDIT CHANGE GATE TIME screen will appear.
2. Use [ ] [ ] [ ] [
parameter you want to change, and use the VALUE dial to
make the desired setting.
Parameter Value
ADrum, ABass,
PART
Acc1–6, ALL
CHORD
Maj, min, 7th
INT1–4,
MAIN1–4,
DIVISION
FILL1–4,
END1–4
From
(MEAS:
0001: 01: 000–
BEAT: TICK)
To (MEAS:
0001: 01: 000–
BEAT: TICK)
Creating a New Style
Explanation
Specifies the lowest pitch whose
velocity is to be modified.
Specifies the highest pitch
whose velocity is to be modified.
] to move the cursor to the
Explanation
Selects the Style part
whose gate times are to
be modified.
Selects the chord.
Selects the division.
Specifies the beginning
of the region whose gate
times are to be modified.
Specifies the end of the
region whose gate times
are to be modified.
17