Darning stitch
q Stitch pattern:
w Thread tension dial:
e Presser foot:
• To sew
z Pull the button holder to the rear.
x Place the garment under the foot. Press the up/down
needle position button twice. Move the fabric to the
left to draw both threads under the foot.
c Lower the foot. Press down the foot control.
The machine will lock stitch, sew 16 rows of darning,
lock stitch again and stop automatically.
v Turn the fabric and repeat sewing.
q Button holder
w Hole
e Starting point
r 3/4˝ (2 cm)
t 7/16˝ (0.7 cm)
• For darning less than 3/4˝ (2 cm)
The size of the darning cycle is variable. The pre-set and
maximum size is 3/4˝ (2 cm) length and 7/16˝ (0.7 cm)
width. For shorter length, set machine to "Low" speed
setting. 4 lock stitches will be sewn first. Then sew to the
desired length and press the reverse button. The desired
length has now been determined. Continue sewing until
the machine stops automatically.
y Reverse stitch button
u Desired length
i Starting point
• To adjust the shape of darning stitch
If one side of the darn is higher than the other, make
them even by pressing the stitch length "+" or "–" key.
When you press the "+" or "–" key, d5 will be indicated
automatically. You can adjust the shape of the darn by
pressing "+" or "–" key, d1 to d9.
• To memorize darning stitch
When repeatedly sewing the same-size darn to repair a
side rip or belt loop, press
18
3 to 6
Automatic buttonhole foot: R
key and restart sewing.
q
q
e
z x c v
y
i
37
w
e
w
r
t
e
u