hpdsm set device alb
Syntax: hpdsm set device=x alb=y/n
Syntax: hpdsm set device=all alb=y/n
The hpdsm set device alb command changes the Adaptive Load Balance setting for the device x
or for all the devices, depending on the input parameter specified.
Example:
hpdsm set device=1 alb=y
Device Name
Device Serial No.
Change Adaptive Load Balance setting (y/n)?
ALB settings changed.
Example:
hpdsm set device=all alb=y
Successful for all the devices.
hpdsm set device path
Syntax: hpdsm set device=x path=y
The hpdsm set device path command changes the preferred path for device x, as shown in the
example below.
NOTE:
Use the hpdsm paths device command to view the available paths for the device.
hpdsm set device=1 path=1
Device Name
Device Serial No.
Controller Port No.
Change Load Balance policy (y/n)?
Preferred Path changed.
hpdsm cleanup device
Syntax: hpdsm cleanup device=x
Syntax: hpdsm cleanup device=all
The hpdsm cleanup device command allows you to clean up the failed path information for a
specified device x, as shown in the example below.
Example:
30
Managing storage arrays using the HP MPIO EVA DSM with the CLI utility
: HP HSV210
: 600508B400101F6A000070001D950000
Verify by using "hpdsm devices" command.
Verify by using "hpdsm devices" command.
: HP HSV210
: 600508B400101F6A000070001D950000
: P8398DXAAQQ013
y
Verify by issuing "hpdsm paths device=<number>" command.
y