Hpdsm Devices All; Hpdsm Paths Device - HP MPIO Installation And Reference Manual

hpdsm devices all

Syntax: hpdsm devices all
The hpdsm devices all command displays information of the device, followed by their path
information as shown in the following example. If there are no devices, the following message is
displayed: No devices found.
NOTE:
See hpdsm set device policy
bus, target, and LUN.
Example:
hpdsm devices all
Device# Device Name
1 HP HSV210
Path# Controller Port#
1 P898DXAAQQO101U-2
2 P898DXAAQQO101U-2
Device# Device Name
2 HP HSV210
Path# Controller Port#
1 P898DXAAQQO101U-2
2 P898DXAAQQO101U-2

hpdsm paths device

Syntax: hpdsm paths device=x
The hpdsm paths device command displays information about the paths available for device x, as
shown in the following example.
NOTE:
• The P.B.T.L. column shows the device port, bus, target, and LUN.
• The RTP column shows the target port information as defined by SCSI-3 specification.
• The Controller Port# column shows the controller serial number followed by target port number.
28
Managing storage arrays using the HP MPIO EVA DSM with the CLI utility
for a definition of the policies. The P.B.T.L. column shows the device port,
Serial No.
6005008B400101F6000170000
State
HBA Slot#
Active 7
Active 6
Serial No.
6005008B400101F600018000
State
HBA Slot#
Active 7
Active 6
Active
Policy
Paths
2 SQST
RTP P.B.T.L
00010002 3.0.2.3
00010002 4.0.2.3
Active
Policy
Paths
2 SQST
RTP P.B.T.L
00010002 3.0.2.4
00010002 4.0.2.4
P.B.T.L ALB
Disk#
Disk1 4.0.2.3 N
P.B.T.L ALB
Disk#
Disk2 3.0.2.4 N