Following Routes And Going To Waypoints; Going To An Individual Target Point - Raymarine Raynav 300 GPS Plotter Owner's Handbook Manual

Chapter 3: Operation

3.5 Following Routes and Going to Waypoints

The default GOTO soft key accesses the functions to follow a route and
Goto a waypoint or cursor. When a target destination is selected, the
GPS Plotter calculates bearing, distance and cross track error (XTE).
This information can be shown on screen and is sent on SeaTalk and
NMEA for use by an Autopilot or display on a compatible SeaTalk or
NMEA repeater. You can also restart the XTE from the vessel's position
and set XTE to zero at that point.
When the GPS Plotter is following a route, the target destination is
indicated by a square around the waypoint and a dotted line shows the
intended track, from your start point or previous waypoint, to the target
waypoint.
This section describes the following:
•
•
•
•
•
An alarm is triggered when approaching a waypoint. This section
describes what occurs when arriving at waypoints. Chapter 4 describes
how to set the alarm.
The GPS Plotter can also display the vessel's actual track which can be
recorded for later display. The Track function is described in Section 3.7,
Using Tracks.
➤
To access the Goto/Follow soft keys, press the GOTO default soft key; the
GOTO soft keys are displayed as shown in Figure 3-39.
WAYPOINT
Note: The soft keys differ if a follow or goto is already in progress.

Going To an Individual Target Point

Rather than following a route, you can go directly to a selected target
point. This can be an existing waypoint (not in the current route) or the
cursor position.
Go to an individual target point (an existing waypoint or the cursor).
Follow a route either forward, or reversed.
Joining a route at a selected waypoint, advancing to waypoints or
restarting XTE.
Stop and Restart Follow/Goto.
Target Point Arrival
GOTO GOTO
CURSOR
Figure 3-39: GoTo Soft Keys
FOLLOW
ROUTE
3-35
D4917_1