Pole Mounting - Raymarine Raynav 300 GPS Plotter Owner's Handbook Manual

5-6

Pole Mounting

➤
Refer to Figure 5-3:
1. Screw the pole mount base to a suitable pole or rail mount bracket,
2. Pass the cable through the centre hole of the pole mount base (A) or
3. Check that the cable is positioned correctly and secure the GPS
Note: Failure to remove the plastic tabs from within the cable channel
could result in cable damage.
having an industry standard 1inch 14TPI thread, until secure.
insert the cable into the side exit channel (B).
Antenna to the pole mount base using the two screws provided.
If the cable is to exit from the side of the GPS Antenna through the
side channel, remove the two plastic tabs obstructing the cable chan-
nel.
Figure 5-3: Pole Mounting Arrangement
Raynav 300 GPS Plotter
.
D4726-2