Trackpad And Cursor - Raymarine Raynav 300 GPS Plotter Owner's Handbook Manual

Chapter 1: Overview
POWER key
Figure 1-1: Raynav 300 GPS Plotter Operating Controls

Trackpad and Cursor

The trackpad is used to:
•
•
•
The cursor is used to:
•
•
•
•
Moving the Cursor
Press the corresponding edge of the trackpad to move the cursor
horizontally, vertically or diagonally; the longer you press, the faster the
cursor moves. The current cursor position is shown in the Status Bar at
the top of the display.
Note: When certain menus and soft keys are displayed, the cursor is not
active. If you find that you cannot move the cursor, it may be because the
unit is in one of these modes. Press CLEAR (repeatedly) until the default
soft keys are displayed; the cursor should then respond.
Soft keys
Move the cursor around the screen
Select an item from a pop-up menu
Adjust a variable soft key control
Select a position on the screen.
Select and, if valid, move an item, e.g. a waypoint, on the screen.
Select an area of the screen to zoom into.
Pan the display.
Soft key labels
1-5
Cursor
Status Bar
DISPLAY key
MARK key
RANGE key
ALARMS key
Trackpad
MENU key
D4925_2
CLEAR key
ENTER key