Creating A New Route - Raymarine Raynav 300 GPS Plotter Owner's Handbook Manual

3-24

Creating a New Route

Note: If there is a current route, it is cleared when MAKE ROUTE is select-
ed. If following the current route you are prompted to STOP FOLLOW.
Press the YES soft key to continue, or NO to abandon route creation. If the
route has not been saved you are prompted to save it.
Routes can be created by either or both:
•
•
After a route has been created, it can be edited as described in Editing a
Route on page 3-33.
➤
To make a new route using the Route Building Table:
Note: In the following, it is assumed that the user is starting from a data
page display with the default soft keys shown (Figure 3-27).
ROUTE
1. Press the ROUTE soft key; the Route soft keys are displayed
ROUTE
2. Press the MAKE ROUTE soft key; the two column Route Building
COWES
GURNARD LEDGE
MAIN CHANNEL
NEEDLES FAIRWAY
PORT SOLENT
001°06^000W
348°
INSERT
WAYPOINT
Using the Route Building Table to select existing waypoints; this
assumes that a number of waypoints already exist.
Placing new waypoints on the screen using the cursor.
GOTO
Figure 3-27: Default Soft Keys (Typical)
(Figure 3-28).
MAKE EDIT
ROUTE
Figure 3-28: Route Soft Keys
Table is displayed with its associated soft keys (Figure 3-29).
WAYPOINTS
50°50^000N
2.30
m nm
REMOVE
WAYPOINT
Figure 3-29: Route Building Table
GPS DATA WPT DATA
SAVE ROUTE
ROUTE LIST
NEW ROUTE
01 HARBOUR
02 MAIN CHANNEL
03 COWES
04 LYMINGTON
50°52^230N
001°02^390W
300° 1.00
m
ACCEPT REVERSE
ROUTE ROUTE
Raynav 300 GPS Plotter
D4921-1
D4983-1
nm
D4985-2