Connecting To The Control Unit - Raymarine ST4000+ Owner's Handbook Manual

81131_8.book Page 49 Thursday, October 7, 2004 11:03 AM
Chapter 5: Installing the ST4000+

Connecting to the control unit

4. Making sure the cable exits at the bottom of the compass, secure
the fluxgate compass using the self-tapping screws provided
3
(No 8 x / in, pan-head).
4
Note: Stick the supplied warning label near to the compass, where it
is clearly visible.
1. The compass is supplied with 8 m (26 ft) of cable. Route the cable
to the control unit, taking into account the EMC installation
guidelines (page 36).
Note: Make sure you leave some spare cable so, if necessary, you can
re-position the compass to reduce deviation. If the standard cable is
not long enough, your Raymarine dealer can supply a 10 m (30 ft)
extension cable (part number: D174).
2. Connect the five cores of the cable as shown to the Compass
terminals on the control unit.
Blue Yellow Green
49
Red
Screen
D3282-2