Table of Contents
Advertisement
PROCEDURE FOR BUILDING AND FITTING MEALSTREAM DOOR (3)
6.
Fit (RHS) and (LHS) door arm assemblies through
slots in cavity and insert door arm pivot pins
through door arms into door frame.
7.
Ensure the door frame is fitted central by using
the following method:
Measure the distance between the side of the door
and the edge of the pin location hole on each side
with the door in the closed position.
Add these two measurements together and divide
by 2.
Adjust hinge adjustment bolt so that the door is
the distance calculated from the side of the door
to the edge of the pin location hole and lock in
position with lock nut.
8.
With both door arms fitted and the door in the
open position, check the door is level and if
necessary apply gentle pressure down on door to
level door. Tighten the top securing bolts on (LHS)
& (RHS) hinges while holding door down.
9.
Fit door springs to door arms and to the hook at
base of inner side panels.
Check operation of door and remove both springs.
Mealstream Ovens Pt. No. 32Z3403 Issue 16
Page 32
Door arm pivot pin
Edge of pin
Door hinge adjustment
location hole
Gentle
downward
pressure
Spring clips
Door
Secure
bolt
Advertisement
Table of Contents
