Garland Mealstream CTM3 Service Manual page 28

PROCEDURE FOR DOOR INTERLOCK ADJUSTMENT AND TEST (2)
DO NOT attempt to carry out the following procedure
Continuity Meter
Door Spacer Kit
Part No. 10C0171
Before starting this test procedure please make sure that the oven is disconnected from
the electrical supply and that the oven power switch (ON/OFF) is in the OFF position.
After each step check that the interlocks are operating in the correct order using a
continuity meter.
Disconnect the microswitches and check for the continuity of the switches with a continuity meter
Step 1: Set the interlock so that they activate in the following order.
When closing the door.
Interlock
SW1 (Monitor)
SW2 (Primary)
SW3 (Secondary)
When opening the door.
Interlock
SW1 (Monitor)
SW2 (Primary)
SW3 (Secondary)
Please Note
unless you have the following tools and parts.
Spacer
S10 Door Spacer 10mm
S5 Door Spacer 5mm
S1 Door Spacer 1mm
WARNING
See Safety Code ( Page 4 )
Order
st
1
nd
2 Note both SW2 and SW3 activate together
nd
2 Note both SW2 and SW3 activate together
Order
rd
3
st
1 Note both SW2 and SW3 activate together
st
1 Note both SW2 and SW3 activate together
Mealstream Ovens Pt. No. 32Z3403 Issue 16
Page 28
No. required Part No.
2 40C1119
2 40C1118
2 40C1114