Aligning The Running Belt; Servicing The Treadmill; Long Term Storage - Precor M9.55 Owner's Manual

CAUTION: After entering the password, the
belt starts moving after the short warning
message, "Belt Starting 3, 2, 1,..." appears
on the display.
CAUTION: If you hear any chafing or the
running belt appears to be getting
damaged, stop the running belt immedi-
ately by pressing the red Stop key.
Contact Precor Customer Support.
3. Turn ON the treadmill.
4. Stand to the side of the treadmill and press Quick Start, enter the password (if
necessary) and then increase the running belt speed to 3 mph (5 kph) by pressing
Speed .
Important: The running belt begins moving automatically after you perform step 4.
5. Observe the running belt for a couple of minutes. The belt should be centered on
the running bed. A few inches from either side of the side rail platform.
6. If the belt needs additional alignment, repeat steps 1 through 4 of this procedure
until the belt is properly aligned.
7. Press Stop (the running belt slows and stops moving). To return to the Precor
banner, press Reset.

Servicing the Treadmill

Do not attempt to service the treadmill yourself except for the maintenance
tasks described in this manual. The unit does not contain any user-serviceable
parts that require lubrication. For information about product operation or service,
call 888-665-4404.

Long Term Storage

When the treadmill is not in use for any length of time, turn it OFF. Ensure that the
power cord is unplugged from the wall outlet and is positioned so that it will not
become damaged or interfere with other equipment or people.
page 43