Maintenance And Cleaning; Oven Exterior; Oven Interior; Bottom Jet Plate Installation - Garland Air Deck Installation And Operation Manual

MAINTENANCE AND CLEANING

CAUTION: Disconnect Power Supply Before Attempting
Cleaning or Servicing

Oven Exterior

Painted Surfaces should be cleaned when cool using a mild
soap and warm water solution on a sponge or soft clean
cloth . Rinse and dry thoroughly with a soft clean cloth .
Stainless Steel Surfaces usually respond to cleaning as
noted above . Stubborn stains or heat tint may require the
use of a commercial type cleaner, such as Penny-Brite or
Copper-Brite, rubbed in with a dry cloth or Paste Nu-Steel,
Daboise Temp or Tarnite, rubbed with a cloth or Stainless
Steel pad . Always rub in the direction of the polished lines .
Rinse thoroughly with fresh water and wipe dry .

Oven Interior

Aluminized Steel Surfaces should be cleaned with a damp
soft cloth and mild household detergent .
The oven deck and bottoms (Jet Plates) are removable . The
deck should be kept as clean as possible . Heavy spills and
carbon deposits, that are not easily removed with a soap and
water solution, should be scraped loose and removed .
Periodic removal of the deck and "Jet Plates" is strongly
recommended . This will enable you to remove any build-up
of deposits on the "Jet Plates", and access the oven bottoms .
Particles may drop through the openings in the "Jet Plates" .
The entire oven bottom should be cleaned at least once a
year and more often under heavy usage conditions .
WARNING: Failure to Clean Oven Perforated Deck Surface
and "Jet Plate" Will Degrade Baking Performance .
Part # 1382615 Rev 2 (01/28/08)

Bottom Jet Plate Installation

After periodic jet plate cleaning, they should be reinstalled in
the following manner .
Plate marked "R or RHT" should be placed into unit on right
hand side .
NOTE: THE SHORT SIDED END OF THE
JET PLATE SHOWN SHOULD BE INSTALLED
IN THE CENTER OF THE UNIT . WITH THE
SHORT END DOWN
(TOWARD BOTTOM OF UNIT) .
The jet plate marked "L or LFT" should be placed on the left
side in the same manner as right plate (See Note) .
Page 11