Precor M9.21i Owner's Manual page 5

Canadian Department of Communications
"This digital apparatus does not exceed the (Class B) limits for radio noise emissions from digital apparatus
set out in the Radio Interference Regulations of the Canadian Department of Communications."
"Le présent appareil numérique n'émet pas de bruits radioéélectriques dépassant les limites
applicables aux appareils numériques (de la class B) prescrites dans le Règlement sur le brouillage
radioélectrique édicté par le ministére des Communications du Canada."
Grounding Instructions
The M9.21i or M9.21si Low Impact Treadmill must be grounded. If it should malfunction or break
down, grounding provides a path of least resistance for electric current which reduces the risk of
electrical shock. The treadmill is equipped with a power cord having an equipment-grounding
conductor and a grounding plug. The plug must be inserted into an appropriate outlet that is
properly installed and grounded in accordance with all local codes and ordinances.
Diagram A
Proper grounding plug and
power outlet for 120v
connection
DANGER
Improper connection of the equipment-grounding conductor can result in a risk of electric shock.
Check with a qualified electrician or service person if you are in doubt as to whether the treadmill is
properly grounded. Do not modify the plug provided with the treadmill—if it doesn't fit the outlet,
get a proper outlet installed by a qualified technician.
The treadmill is for use on a nominal 120-volt circuit (refer to the WARNING below and to the Installa-
tion Requirements on page 9) and has a grounding plug that looks like the plug illustrated in Diagram
A.
WARNING
This product is rated for use on a circuit having a nominal rating of 120 volts, 15 amps and is
factory-equipped with a specific electric cord and plug to permit connection to a proper electric
circuit. Make sure that the product is connected to an outlet having the same configuration as the
plug. No adapter should be used with this product. If the treadmill must be reconnected for use on
a different type of electric circuit, the reconnection should be made by qualified service personnel.
ATTENTION: Haute Tension
Débranchez avant de réparer
page 5