Serial
Port
Air
Exhausts
Power Output
Receptacles
UPS Cabinet
External Battery Connector
UPS Startup for 120V Models
To start up the UPS for 120V models:
Powerware
9 Prestige Series User's Guide (600 VA - 1800 VA)
®
Breaker
Input Connector
Battery Output
Connector
Figure 4. Typical UPS Rear Panel
1. Plug the UPS power supply cord into the input connector on
the UPS rear panel.
2. Plug the other end of the power supply cord into a grounded,
three-wire, AC receptacle that has been wired in accordance
with NEC specifications.
The UPS performs diagnostic tests and enters Normal mode
with the equipment (load) offline. The
lit. The startup should take about 15 seconds.
:
www.powerware.com
Battery Cable
Battery Input Connector
indicator remains
Installation
Battery
Circuit Breaker
Breaker Tie
Battery Cabinet
31