Ups Startup; Startup For The Fe And Qfe 500 Va-3.1 Kva Ups - Powerware Ferrups FE/QFE UPS User Manual

C H A P T E R 3
UPS S
TARTUP
This section provides step-by-step instructions for starting the
Powerware FERRUPS UPS. Follow these procedures closely to avoid
potential damage to your equipment or the UPS and to protect yourself
and others from hazardous operating conditions.
Startup for the FE and QFE 500 VA–3.1 kVA UPS
To start the FE and QFE 500 VA–3.1 kVA UPS, use the following steps:
1. Confirm the equipment to be protected by the UPS is powered
2.
NOTE If the plug does not match your receptacle outlet, ask your electrician to install
the proper outlet.
NOTE Do not use the cord supplied with the UPS; this cord is for plugging the
equipment into the UPS output receptacles.
NOTE If the plug does not match your receptacle outlet, ask your electrician to install
the proper outlet.
NOTE If you need to order a UPS power cord, please call your service representative.
Powerware FERRUPS FE/QFE UPS (500 VA–18 kVA) User's Guide
®
off.
For FE Plug-Receptacle UPSs:
power outlet.
For QFE Plug-Receptacle UPSs:
the computer or other equipment to be protected by the UPS
and plug it into the UPS. Plug the other end of the power cord
into a power outlet.
Confirm that an electrician has completed
For Hardwired UPSs:
and tested the connection to the proper power source and
connected your protected equipment according to the
Powerware FERRUPS FE/QFE UPS (500 VA–18 kVA) Installation
Guide. Turn the AC line disconnect switch to the ON position.
Rev A www.powerware.com
Plug the UPS power cord into a
Disconnect the power cord from
17