Troubleshooting Tips - Powerware Prestige series 9 User Manual

Installation

Troubleshooting Tips

If you should encounter any problems during startup, see the
troubleshooting chart on page 57.
The UPS is shipped with the battery(s) charged. However, batteries may
lose some of the charge during shipping and storage. You can use the
UPS immediately after unpacking, but it may not provide the full-rated
backup time during a power failure. Upon initial startup, the UPS may
need to operate for approximately 8 hours before the battery is fully
charged and full battery-backup time is available. If the Battery Fault
indicator flashes, operate the UPS for 24 hours to fully charge the
battery.
34
12. Press and hold the Output On button until you hear the UPS
beep (approximately one second).

The indicator remains lit and the Self Test indicator turns
on. The front panel displays the percentage of full load being
applied to the UPS. The UPS is now in Normal mode with the
load online. See "Normal Mode" on page 36 for more
information.
Powerware 9 Prestige Series User's Guide (600 VA - 1800 VA)
®
:
www.powerware.com