Weider MAX XP400 User Manual page 8

9, 9
Attach two 8mm MetaUSpacers (91), a 60mm
MetaU Spacer (39), and two Bearing WheeUs (46)
to one end of the Seat Carriage (12) with an M8 x
104mm Button Head BoUt(60) and an M8 NyUon
Locknut (65) as shown, Make sure that the parts
are oriented as shown in the inset drawing; the
Seat Knob (not shown} wHJ not engage the
Bench Rail (not shown} if they are incorrectly
oriented. Do not overtighten the Locknut; the
Bearing Wheels must be able to roll easily.
Attach two Bearing Wheels (not shown} to the
other end of the Seat Carriage (!2) in the
same manner.
10, Attach the Seat Knob (45) to the Seat Carriage
(12) with two M6 x 13mm BoUts(92) and two M6
NyUon Locknuts (69), Make sure that the slot in
the Knob is aligned with the slot in the Seat
Carriage, as shown.
Orient the Seat (13) and the Seat Carriage (12)
as shown, Attach the Seat to the Seat Carriage
with four 1/4" x 16mm Screws (82),
11, Pull out the Seat Knob (45) as far as it wHU go, and
set the Seat Carriage (12) on the Bench Rail (5),
LooseUy attach two 8mm Metal Spacers (91), a
60mm Metal Spacer (39), and two Bearing
Wheels (46) to the center holes in the Seat
Carriage (12) with two M8 Flange Nuts (19) and
the M8 x 114mm Axle (57), Make sure that the
serrated edge of the Flange Nuts are against
the Seat Carriage.
While a second person presses down on the Seat
(13), hold the wheel assembly firmly against the
bottom of the Bench Rail (5) and properly tighten
the M8 Flange Nuts (19), Make sure that three
threads are extending past the Nut, and that
the wide sides of aH six WheeJs (46) are
pressed against the Bench Rail.
Engage the Seat Knob (45) into an adjustment
hole in the Bench Rail (5),
10
11
6O
91 _
46
39
91
46
12
second
set of wheels
here
Side
39
46
!1
12_
82
Slots
92
19 13
/
57
45
.i139
91
\
Adjustment Hole
39 46
)1
Side
8