Weider MAX XP400 User Manual page 5

Make Things Easier for Yourself
This manual is designed to ensure that the resist-
ance system can be assembled successfully by
most peopb, However, it is important to realize
that the versatile resistance system has many
parts and that the assembly process wiii take
time, Most people find that by setting aside plenty
of time. assembly wiUigo smoothly
Before beginning assembly, carefully read the
following information and instructions:
Assembly requires two persons,
Place all parts in a cleared area and remove the
packing materials, Do not dispose of the packing
materials until assembly is completed,
• For help identifying sma//parts, use the PART
iDENTIFICATION CHART. Note: Some small
parts may have been pre-attached for shipping, if
a part is not in the parts bag, check to see if it
has been pre-attached,
• Tighten all parts as you assemble them, unless
instructed to do otherwise,
As you assemble the resistance system, make
sure all parts are oriented as shown in the draw-
ings,
The included AHen wrenches _ and the follow-
ing tools (not incJuded) are required for assem-
bly:
* Two adjustable wrenches
One rubber mallet
• One standard screwdriver __
* One Phillips screwdriver
Lubricant, such as grease or petroleum jelly,
and soapy water.
Assembly wiii be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches,
Before beginning assembly, make sure that
you have read and understand the informao
tion in the bo× abovel
Attach two Plastic Feet (53) and two Large Plastic
Feet (9) to the Base (1) with four M4 x 16mm
Screws (62),
Attach the Upright (3) to the Base (1) with two
MIO x 66mm Carriage Bolts (83), two MIO x
72mm Bolts (64), and four MIO Nylon Locknuts
(76) as shown. Note: This step witt be easier if
the Upright and Base are tipped on their
sides.
62
1\
iii i'
64