Relationship Between Connection Of Cables Supplied With Vx-8 And Line Number - Hitachi GR2000 Series Installation Manual

The cables attached to VX-8 have
a length of 1 m.
The cables
attached to VX-8
50-pin half-pitch connector
7 5
# 6
5 6
When connecting the cables attached to VX-8 to the devices, tighten the connectors lightly to the standard torque of 1.5
kgf/cm by using a screw driver (a small sized screw driver is recommended). Be extremely careful not to over-tighten
(which may cause the bolts to break).
Figure 3-27 Relationship between connection of cables supplied with VX-8 and LINE
GR2K-GA-1002
Rev. 6.03
Be careful when connecting the cables attached to VX-8 to the devices that the
connector insertion faces are reversed between the lower side connectors (LINE 0,
LINE 1, and LINE 4, LINE 5) and the upper side connectors (LINE 2, LINE 3, and
LINE 6, LINE 7).
LINE 5 LINE 4
50-pin half-pitch connector
LINE 7 LINE 6
. + 0 ' 
LINE 5 LINE 4
100-pin high-density connector
number
LINE 7 LINE 6
LINE 1
50-pin half-pitch connector
equivalent to that for NWVX-4
The existing interface cables
(V.24, V.35, X.21)
LINE 3 LINE 2
; . + 0 ' ' 4 4
8     8     :   
) # % 6  6  4



LINE 1 LINE 0
Small screw driver is recommended
Component Details
LINE 3 LINE 2
100-pin high-density connecto
LINE 0
. + 0 ' 


8 :
0 9


3-27