Vent Diagrams - Heat & Glo 6000CMOD-IPI Owner's Manual

E. Vent Diagrams
Top Vent - Horizontal Termination
Note: The 6000/8000 series fi replaces can adapt to SLP series
vent pipe, if desired.
When venting off the top of the unit, use a DVP-2SL adapter and a
minimum 48 inch vertical section of SLP series vent pipe.
A DVP-SLP24 adapter may also be used with a 24 inch vertical
section of SLP series vent pipe.
After the 48 inch vertical section, the venting table rules must be
followed. The fi rst 48 inch vertical section is NOT counted as part
of the vertical components in the table. It is still counted as part of
the overall maximum run. All venting table rules for the vent run
must still be followed.
Example: DVP pipe 3 ft. min. vertical = 11 ft. max. horizontal
SLP pipe 7 ft. min. vertical = 11 ft. max. horizontal
Top Vent - Horizontal Termination
One Elbow
V
1
Elbow only
6 in.
1 ft.
1-1/2 ft.
2 ft.
2-1/2 ft.
3 ft.
V
1
Note: For corner installations: A 6 inch (152
mm) section of straight pipe may need to
be attached to the appliance before a 90º
elbow, to allow the vent pipe to clear the top
standoffs.
Figure 7.3
26
6000CMOD-IPI
Minimum H Maximum
1
2 ft
152 mm 4 ft.
305 mm 6 ft.
457 mm 10 ft.
610 m 15 ft.
762 mm 18 ft.
914 mm 20 ft.
+ H = 40 ft. (12.2 m) Maximum
1
H = 20 ft. (6.1 m) Maximum
1
Heat & Glo • 6000CMOD-IPI, 8000CMOD-IPI • 2241-900 Rev. i • 4/13
Fire Risk.
• When using DVP-HRC-SS and DVP-HRC-ZC-
V Minimum
1
610 mm Elbow Only
1.2 m 1 ft.
1.8 m 2 ft.
3.0 m 3 ft.
4.6 m 4 ft.
5.5 m V
1
6.1 m
H
1
WARNING
Fire Risk. Explosion Risk.
Do NOT pack insulation or other combustibles
between ceiling fi restops.
• ALWAYS maintain specifi ed clearances around
venting and fi restop systems.
• Install wall shield and ceiling fi restops as speci-
fi ed.
Failure to keep insulation or other material away
from vent pipe may cause fi re.
WARNING
SS termination caps on top vented fi replaces, a
6 inch minimum vertical vent section is required
before installing fi rst elbow.
8000CMOD-IPI
H Maximum
1
2 ft. 610 mm
305 mm 3 ft. 914 mm
610 mm 6 ft.
914 mm 11 ft.
1.2 m 20 ft.
+ H = 40 ft. (12.2 m) Maximum
1
H = 20 ft. (6.1 m) Maximum
1
V
1
1.8 m
3.4 m
6.1 m