Step 3 Installing The Vent System; Vent System Approvals - Heat-N-Glo 8000 DVTFL Installer's Manual

Step 3
Installing the
Vent System
Vent system
termination kits
D-SERIES
TERMINATION KITS
DVK-TVCD
DVK-01D DVK-01D
DVK-02D DVK-02D
DVK-01TRD DVK-01TRD
DVK-02TRD DVK-02TRD
DVK-01SD DVK-01SD
DVK-02SD DVK-02SD
SL-D-SERIES
TERMINATION KITS
SLK-TVCD SLK-TVCD
SLK-01D
SLK-991D SLK-991D
SLK-01TRD
Figure 6. Vent Components and Terminations
A. Vent System Approvals
Models 8000DVTFL, 6000DVTFL, 6000XLT, and
6000ARCH are approved to use D-series direct vent
pipe components and terminations. Model SL-
42DVT is approved to us SL-D-series components
and terminations. Approved vent system components
are labeled for identification. NO OTHER VENTING
SYSTEMS OR COMPONENTS MAY BE USED.
Detailed installation instructions are included with
each vent termination kit and should be used in
conjunction with this Installers Guide . The drawing
below shows vent system components and
terminations.
Identifying Vent Components
The vent systems installed on this gas fireplace may
include one, two, or three 90° elbow assemblies. The
relationships of vertical rise to horizontal run in vent
configurations using 90° elbows MUST BE strictly
adhered to. The rise to run relationships are shown in
the venting drawings and tables. Refer to the
diagrams on the next several pages.
VERTICAL VERTICAL
TERMINATION TERMINATION
HORIZONTAL HORIZONTAL
TERMINATION TERMINATION
WALL FIRESTOP
90 DEGREE 90 DEGREE
ELBOW ELBOW
Vent system components
COMPONENT IDENTIFICATION
STORM COLLAR
ROOF FLASHING
HORIZONTAL PIPE HORIZONTAL PIPE
SUPPORT SUPPORT
PIPE LENGTH
CEILING CEILING
WALL BRACKET
FIRESTOP FIRESTOP
8