Pentax K-5 Operating Manual page 148

3
4
Press the
MENU
button.
The screen that was displayed before selecting the menu appears again.
Aim the camera at the subject and press the shutter
release button halfway.
The following indicators appear on the status screen.
((,111t_ Shake Reduction On + Horizon Correction On
(_ Shake Reduction Off + Horizon Correction On
• Set [Shake Reduction] to (L'_,_ (Off) when using the camera with a tripod or
when this function is not needed.
• The Shake Reduction function automatically turns off in the following
situations. Note that the Shake Reduction function cannot be selected when
the following functions are set.
B (Bulb) mode
- Self-timer shooting
- Remote Control shooting
- Mirror Lock-up shooting
- when [Auto Align] is set to [] (Off) in the [HDR Capture] setting
o
- when using the flash in wireless mode =
• The Shake Reduction function will not fully work (for about 2 seconds) right
after turning on the camera or restoring from Auto Power Off. Wait for the
Shake Reduction function to become stable, and then press the shutter
button gently. If ((4Ill)) appears in the viewfinder when you press the shutter
release button halfway, the camera is ready to take a picture.
• The Shake Reduction function is available with any IC'5 compatible
PENTAX lens. However, when the aperture ring is set to a position other than
the A (Auto) posit on for a lens with a A position or a lens without an A
position is used, the camera will not operate unless [27. Using Aperture Ring]
is set to [Permitted] in the [C Custom Setting 4] menu. Set this beforehand.
In such cases, however, some functions will be restricted. Refer to "Notes on
[27. Using Aperture Ring]" (p.339) for details.