NordicTrack SL710 NTC07940 User Manual page 6

2, While another person Hfts the rear of the Frame (1),
attach the Rear Stabilizer (16) to the Frame with four
M8 x 40mm Button Screws (54) and four M8 Split
Washers (55),
3, While another person hoHds the Upright (2) in the posi-
tion shown, connect the Upper Wire Harness (97) to
the Lower Wire Harness (43), Gently puHH the upper
end of the Upper Wire Harness to remove any shack
from the Wire Harnesses,
Hnsertthe Upright (2) into the Frame (1), Be carefuJ to
avoid pinching the Wire Harnesses (43, 97). Attach
the Upright with two MIO x 118mm Button Screws (78),
two MIO Split Washers (88), and two Upright Spacers
(99), Make sure the concave end of each Upright
Spacer is turned toward the Upright.
4, Hdentify the Left HandHebar (70), which is marked with
an "U' sticker, HoHdthe Left HandHebar near the Upright
(2), Connect the HeftPuHse Sensor Wire (6) to the
PuHseWire (3),
SHde the Left HandHebar (70) onto the indicated tube
on the Upright (2), Be careful to avoid pinching the
teft Pulse Sensor Wire (6} or the Pulse Wire (3}.
CarefuHHy insert two M8 x 40mm Button BoHts(81)
through the Left HandHebar and the tube on the
Upright, Be careful not to damage the Wires with
the Button BoJts. Tighten the two Button BoHtsinto
two M8 NyHon Locknuts (89), Make sure the NyJon
Locknuts are seated in the he×agonal hotes in the
Left Handlebar.
Attach the Right Handlebar (72) in the same way,
78
\
\
\
54
97
43
99
Make sure the
wire harnesses
do not get
and
damaged during
this step.
Make sure the wires
do not get damaged
during this step.
Tube
81
6
72
89 \
\
\
\
\