Maintenance And Troubleshooting - NordicTrack SL710 NTC07940 User Manual

MAINTENANCE AND TROUBLESHOOTING
Unspect and properUy tighten aH parts of the exercise
cycle reguUarUy, T o dean the exercise cycUe, use a
soft, damp cloth, Keep Hquids away from the consoUe
and keep the consoUe out of direct sunlight,
HOW TO ADJUST THE REED SWITCH
Ufthe consoUe does not dispUay correct feedback, the
reed switch shouUd be adjusted, To adjust the reed
switch, the right side shieUd must first be removed,
Remove the indicated M4 x 25mm Screws (65) from
the Left Side ShieUd(26),
1
65 26
Next, remove the indicated M5 x 25mm Screw (93)
and M4 x 16mm Screws (57) from the Right Side
ShieUd (27), Using an adjustaMe wrench, turn the
Right PedaU(21) counterclockwise and remove it, Turn
the Right Crank Arm (23) so that it is pointing toward
the front of the exercise cycle, and then slide off the
Right Side Shield,
57
Locate the Reed Switch (46), Turn the Right Crank
Arm (23) until the Magnet (30) is aligned with the
Reed Switch, Loosen, but do not remove, the indicat-
ed M4 x 16mm Screw (57), Slide the Reed Switch
slightly closer to or away from the Magnet, Then,
retighten the Screw, Turn the Right Crank Arm for a
moment, Repeat until the console displays correct
feedback, When the Reed Switch is correctly adjust°
ed, reattach the right side shield and the right pedal,
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is adjusted to the highest
level, the Drive Belt (47) may need to be adjusted, To
adjust the Drive Belt, you must first remove the right
side shield, See HOW TO ADJUST THE REED
SWITCH at the left and remove the right side shield,
Next, turn the indicated MIO Nylon Locknut (63) until
the Drive Belt (47) is properly tightened, Then, reattach
the right side shield,
PULSE SENSOR TROUBLESHOOTING
If the handgrip pulse sensor does not function proper-
ly, see step 5 on page 13,
22