Assembling The Unit - Craftsman Incredi-Pull 316.29256 Operator's Manual

ASSEMBLING THE UNiT
Before operating, position the unit's handlebars.
NOTE: You may also need to reposition the roller height
before using the cultivator. Refer to the Adjusting
Tine Depth section.
Begin by carefully unpacMng the contents and maMng
sure that nothing is damaged.
POSiTiONiNG THE HANDLEBARS
1. Loosen the two knobs on the inside of the
handlebars (Fig. 1).
2. With the unit upright, swing the handlebars up into
the operating position (Fig. 1).
NOTE: Take care not to pinch the throttle cable or
switch wires when positioning the handlebar.
3. Tighten the knobs to secure the handlebars in place
(Fig. 2).
NOTE: Do not over-tighten the knobs,
4.
Readjust the throttle cable and switch the wires so
they are smooth and tight against the handlebar
assembly. This will help prevent them from catching
or snagging during normal operation.
NandJebar
Knobs
Handmebar
Knobs
Fig. 1
Home
Bott
Nandmebar
Knob
" _ NandBebars
F_g. 2
INSTALLING THE TRANSPORT
ROLLER
ASSEMBLY
If the roller assembly is not installed, or if you ever need
to remove or reinstall it, perform the following
instructions:
WARNING: To avoid njury from
the tines, wear
heavy gloves and a long sleeve shirt when
installing the roller assembly.
WARNING: To preventser ous
personal injury, the
roller assembly must be installed when
operating the unit.
1. With the unit on its side, place the transport roller
assembly on the underside of the tine guard (Fig. 3).
Guard
Roller
Assembly
Wing Nuts &
Lock Washers
F_g. 3