Craftsman Incredi-Pull 316.29256 Operator's Manual page 16

CAUSE
Empty fueHtank
Primer buHbwasn't pressed enough
Engine is flooded
OHdfueH
FouHed spark pHug
Mugged spark arrestor
EZ Fire Heverwasn't flipped/set
The outside temperature is bellow 40 ° F
The outside temperature is above 90 ° F
CAUSE
Air fiHteris pHugged
OHdfueH
Improper carburetor adjustment
CAUSE
OHdfueH
Improper carburetor adjustment
Mugged spark arrestor
CAUSE
OHdfueH
Improper carburetor adjustment
FouHed spark pHug
Mugged spark arrestor
CuHtivator tines bound with debris
ACTION
Fill fueHtank with new fueH
Press primer buHbfully and showily 10 times
Squeeze the trigger and pull the starter rope
Drain gas tank and add fresh fuel
Replace or clean the spark plug
Clean or replace spark arrestor
Move lever to the starting position
Pull the starter rope up to 10-15 times
Squeeze the throttle control and pull the starter rope
ACTION
Replace or clean the air filter
Drain gas tank and add fresh fuel
Adjust according to the Carburetor Adjustments section
ACTLON
Drain gas tank and add fresh fuel
Take to a Sears Parts & Repair center or other qualified
service dealer for an adjustment
Clean or replace the air filter
Clean or replace spark arrestor
ACTION
Drain gas tank and add fresh fuel
Take to a Sears Parts & Repair center or other qualified
service dealer for an adjustment
Replace or clean the spark plug
Clean or replace spark arrestor
Stop the unit, switch the On/Off Stop Control to
STOP, clean and remove any debris binding the tines
CAUSE ACTION
Spark plug gap is too small/close Adjust gap to 0.020 inch (0.50 mm)
NOTE: For repairs beyond the minor adjustments listed above, contact your nearest Sears Parts &
Repair center (1 800 4 M%HOME ®) or other qualified service dealer for an adjustment.
16