Philips CCB252AT Owner's Manual page 44

I
Press the MENU button.
> SMARTLOCK I PRESS_
IvEVIEW
EXIT
PRIM SETUP
VCR PROGRAM
CP, SETUP
2
Press the PLAY/A button or the STOP/Y button to select
SMARTLOCK.Then, press the F.FWD/I_ button.
f
SMARTLOCK
Enter "(our Access Code
3
Use the Number buttons to enter your old access code.
The default code is 071 I. If you have never set up your personal
access code, use 071 I now.
After you enter the code, the SMARTLOCK menu will appea_
Enter Your Access Code
4
Press the PLAYI& button or the STOP/Y button to select
CHANGE CODE.Then, press the F.FWD_ button.
IT Sr_ARTLOCK _'_
BLOCK
• CHANGE CODE
SELECT &v CHOOSE IP
O END PRESS EXIT
5
Use the Number buttons to enter your desired access code
in the New Code space.Then, enter the same code in the
Confirm Code space.
Your new access code should be recorded.You will return to the
SMARTLOCK menu.
nflrrn Code
6
Press the STATUS/EXIT button.
24
I
Helpful Hints
In order to protect the privacy of
the access code, an X will appear
on the screen instead of the num-
ber you enter.
If a "Wrong Code..." message
appears on the screen after you
complete step 5, you entered the
wrong numbers in the Confirm Code
space. Repeat the steps on this
page.
You cannot use the default code
after you set up your personal
access code.
If a power failure occurs, the default
code, 071 I, will be the active access
code again.
If you connect the power cord to an
AC outlet that is controlled by a wall
switch, your personal access code
will be erased every time you turn
off the power at the wall switch. The
default code will be the active code
again.