General; Supplied Accessories; Environmental Information; Care And Safety Information - Philips MC-M570 Manual

General Information
Refer to the type plate on the rear or
bottom of the system for identification
and supply ratings.
Supplied accessories (page3. P1)
USB PC LINK software installer C©RON
USB cable
Remote control and two AA battenes,
AM loop autenna
FM wire antenna
AC power cord
Environmental information
All unnecessary packaging has been omitted,We
have tried to make the packag ng easy to
separate into thrx'e materiaB: cardboard (box),
polystyrene foam (buffer) and polyethylene (bags,
protective foam sheet).
Your- system consists of materials which can be
recycled and reused if disassembled by a
specialized compang Please observe the local
regulations regarding the disposal of packaging
matepiais, exhausted battepies and old
equipment,
Care and safety information
(page 3 . P2)
Avoid high temperatures, moisture,
water and dust
Do not expose the system, batteries or dscs
to humid t>_rain, sand or excessive heat (caused
by heating equipment oP direct sunlight), Always
keep the disc tray closed to avoid dust on the
lens.
Avoid condensation problem
The lens may cloud ovep when the system is
suddenly moved from cold to warm
surroundings, making it impossible to play a disc.
Leave the system in the warm environment until
the moistuPe evaporates.
Do not block the vents
In a cabinet, allows about 10cm (4 inches)of
free space all around the system for adequate
ventibtion,
Care of disc
To clean a CD, wipe tt in a straight line from
the center towards the edge using a soft, lint- fr_e
cloth, A cleaning agent may damage the disc!
Wrtto only on the printed side of a CDR(W)
and only with a soft felt-tippeq pen,
Handle the disc by Rs edge, do not touch the
surface,
Care of the cabinet
Use a soft cloth slightly moistened w_th a mild
deterge_t solution. Do not use a solution
containing alcohol, spipits, ammonia or abrasives,
Finding a suitable location
Place the system or] a flat, hard, and stable
surface.
Built-in safety circuit
Under extreme condkions, this system may
switch to standby mode automaticall}4 I[this
happens, let the system cool down before
reusing }t.
Power saving
This system is designed to use less than IW
of electricity when switches to Eco Power
standb}4 Disconnect the AC power cord from
the power outlet when not in use.
3139 115 22181