Table of Contents
Advertisement
All manuals and user guides at all-guides.com
CONTENTS
General Information ................. 5
Safety Information .................... 5
Preparation .......................... 6 - 7
Controls ................................. 8 - 9
Operating The System ................
............................................ 10 - 11
CD ....................................... 12 - 14
Tuner .................................. 14 - 15
Tape ................................... 15 - 16
Aux ............................................. 16
Recording ......................... 17 - 18
Clock ......................................... 18
Timer ......................................... 19
Sleep Timer ............................. 19
Specifications ......................... 20
Maintenance ............................ 21
Troubleshooting .............. 21 - 22
pg 01-22/C10/22-Eng
5
GENERAL INFORMATION
General Information
Accessories
• The type plate (which contains the
- Remote control
serial number) is located at the rear
- Batteries (two AA size) for remote
of the system.
control
• Recording is permissible if
- AM loop antenna
copyright or other rights of third
- FM wire antenna
parties are not infringed.
- AC power cord
• This product complies with the
radio interference requirements of
Safety Information
the European Community.
• Before operating the system, check that
the operating voltage indicated on the
Environmental Information
typeplate (or the voltage indication
All unnecessary packaging has been
beside the voltage selector) of your
omitted. We have tried to make the
system is identical with the voltage of
packaging easy to separate into three
your local power supply. If not, please
materials: cardboard (box), polystyrene
consult your dealer. The typeplate is
foam (buffer) and polyethylene (bags,
located at the rear of your system.
protective foam sheet).
• When the system is switched on, do not
move it around.
Your system consists of materials which
• Place the system on a solid base (e.g. a
can be recycled and reused if disassembled
cabinet).
by a specialized company. Please observe
• Place the system in a location with
the local regulations regarding the disposal
adequate ventilation to prevent internal
of packaging materials, exhausted
heat build-up in your system.
batteries and old equipment.
Allow at least 10cm clearance from the
rear and the top of the unit and 5cm
from each side.
• Do not expose the system to excessive
moisture, rain, sand or heat sources.
SAFETY INFORMATION
• Under no circumstances should you
(Supplied)
repair the system yourself, as this will
invalidate the warranty!
• If the system is brought directly from a
cold to a warm location, or is placed in a
very damp room, moisture may
condense on the lens of the CD unit
inside the system. Should this occur, the
CD player will not operate normally.
Leave the power on for about one hour
with no disc in the system until normal
playback is possible.
• Electrostatic discharge may cause
unexpected problems. See whether
these problems disappear if you unplug
the AC power cord and plug it in again
after a few seconds.
• To disconnect the system from the
power supply completely, remove
the AC power plug from the wall
socket.
CLASS 1
LASER PRODUCT
3/7/00, 5:04 PM
5
3139 116 19311
Advertisement
Table of Contents
