Operating Hints; Vcr To Vcr Dubbing - Sears LXI series 580.55154490 Owner's Manual

OPERATING HINTS ....
• After you have finished using the VCR, rewind,
eject and remove the cassette. Place the
cassette in its protective sleeve to protect it from
dust. It is not necessary to rewind the cassette
before removing it, but if you do, it will be ready to
play or record the next time you use it.
• Be sure the VCR "CHANNEL" selector is on the
correct channel you wish to record. The channel
that is being recorded can always be checked by
setting the television on the VCR channel (3 or 4)
and setting the "VCR/TV" selector to "VCR".
• Always reset the "COUNTER" to "0:00:00" when
you start using a cassette. Make a note on the
cassette what number the "COUNTER" reads
when the recording is finished. Any other locations
on the tape can be noted on the cassette label
also, if desired so you can quickly locate them
later.
• Do not attempt to hook up more than one
television set to the VCR for either recording or
playback.
• ERASE PREVENTION TAB
If you wish to save a recording and prevent
accidental erasure, remove the erase prevention
tab from the cassette. This will prevent recording
on the cassette. Later, if you wish to record, stick
two layers of cellophane tape over the opening.
VCR TO VCR DUBBING
If you wish to exchange or copy some of your friend's favorite home recordings, the following instructions can
be used to connect on VCR to another for this purposed.
CONNECTIONS
Connecting Cables are not supplied except as notated.
VCR 1: To playback _ VCR 2: To record
_ °_
1.Connect VIDEO OUT/AUDIO OUT of VCR 1 to NOTE: If you connect the "VHF/UHF OUTPUT"
VIDEO IN/AUDIO IN of VCR 2. connector of VCR 2 to the "TV ANT" connector, as
2. Set Input Select Button of VCR 2 to A/V mode. illustrated, and press the "VCR/TV" selector to turn
3. Play the tape on VCR 1 and record it on VCR 2. the " _ " indicator on, the picture being dubbed by
VCR 2 can be monitored.
- 59 -