Table of Contents
Advertisement
This function allows youtofullyutilize the
available tape length for timer recording. The VCR calculates the
remaining tape amount and then adjusts the tape speed from SP to SLP as needed.
If it is suspected that the end of the tape will be reached before the reserved program ends (as long as SP mode is
kept all the way), set recording mode to AUTO. This function is available only with Program No. 1 and Quick Set
Program.
The auto mode starts recording in SP mode. The internal circuit compares the rest of the program against the
available tape length. If the internal circuit determines that the available tape is not long enough to record the
program in the SP mode, the Recording mode is automatically changed to SLP mode. This will assure coverage
of the desired timer program before the end of the tape is reached.
Conventional Video Recording
Recording in SP mode for 40 minutes
Tape End
I
20minutesoftheprogram is
left unrecorded
Just-in Time Recording
g In SP mode
for 30 minutes
I
|Recording
in SLP mode
, _ .,
F for 30 minutes
_.
Recording mode automatically
changes to SLP mode
Notes:
• Set the tape remainder
switch ("~T60",
"~T130" or "TI40 J) to the tape loaded.
See "Setting the Remaining
Time" on next page.
• Even if SLP mode is selected, just-in
time recording
cannot compensate
for a tape length which may be too
short.
• A momentary
picture break up will occur at the point on the tape when the recording
speed changes from SP
to SLP.
• The displayed
remaining
tape running time may not always match the actual remaining
time on the tape (usually
longer than the actual time). It is recommended
to set the end of the reserved
recording
time several minutes
after the end of the TV program.
- 26 -
EN
6A12
Advertisement
Table of Contents
