Table of Contents
Advertisement
Thisfunction allows youtofullyutilize theavailable t ape length fortimerrecording. TheVCRcalculates the
remaining tape amount and then adjusts thetape speed f romSP toSLP as needed.
If it is suspected that the end of the tape will be reached before the reserved program ends (as long as SP mode is
kept all the way), set recording mode to AUTO. This function is available only with Program No. 1 and Quick Set
Program.
The auto mode starts recording in SP mode. The internal circuit compares the rest of the program against the
available tape length. If the internal circuit determines that the available tape is not long enough to record the
program in the SP mode, the Recording mode is automatically changed to SLP mode. This will assure coverage
of the desired timer program before the end of the tape is reached.
Conventional Video Recording
Recording In SP mode for 40 minutes
Tape End
I
20 minutes oftheprogram is
left unrecorded
Just-in Time Recording
Recording
in SP mode
for 30 minutes
d
tRecording
in SLP mode
,
for 30 minutes
Recording mode automaticall;
changes
to SLP mode
Notes:
• Set the tape remainder switch ("-T60",
"~T130" or "T140J'
to the tape loaded. See "Setting
the Remaining
Time" on next page.
• Even if SLP mode is selected, just-in
time recording
cannot
compensate
for a tape length which may be too
short.
• A momentary
picture break up will occur at the point on the tape when the recording
speed changes
from SP
to SLP.
• The displayed
remaining
tape running time may not always match the actual remaining
time on the tape (usually
longer than the actual time). It is recommended
to set the end of the reserved
recording
time several minutes
after the end of the TV program.
EN
-28-
6A12
Advertisement
Table of Contents
