Sears LXI series 934.55116690 Owner's Manual page 7

vIDEO CA iSE*.I**I'E IAI E
This VCR will operate with any cassette that has the VHS mark. For best results, we recommend the use of
high-quality tapes. Do not use poor quality or damaged tapes.
PRECAUTIONS
• Avoid moisture. Moisture condensation may occur
on the tape if it is moved from a cold place to a warm
place. Before using a tape with these conditions, to
avoid a damage of the tape and your VCR, wait until
the tape has warmed to room temperature and the
moisture has evaporated.
• Avoid extreme heat, high humidity and magnetic
fields.
• Do not tamper with the cassette mechanism.
• Do not touch the tape with your fingers.
INSERTING A CASSETTE
Insert the cassette in the direction as shown. Push in
gently, but continuously, on the center-back of the cas-
sette until it is drawn into the VCR.
The VCR will automatically turn on.
Inl lJ LI J "_lUl
tt_l "_ J
CORRECT f _D.
WRONG
THREE DIFFERENT TAPE SPEEDS
Before recording, select the tape speed from : SP mode
(Standard Play), LP mode (Long Play) or SLP mode
(Super Long Play).
The table below shows the maximum recording/play-
back time using T60, T120 or T160 tapes in each mode.
Tape Speed
Type of tape
SP mode
LP mode
SLP mode
Recording/Playback Time
T60 T120 T160
1 hour 2 hours 2-2/3 hours
2 hours 4 hours 5-1/3 hours
3 hours 6 hours 8 hours
REMOVING A CASSETTE
1) In the Stop mode, press EJECT button on the remote
control or press STOP/EJECT button on the VCR.
The cassette will be ejected.
2) Pull the cassette out of the cassette compartment.
3) Store the cassette in its case as shown.
ERASE PREVENIION
You can prevent accidental
erasing of recording by
breaking off the tab on the
back edge of the cassette.
If you decide to record on
the tape again, cover the
hole with a plastic tape.
EN
- '7 - 6A12