Stainless Steel Surfaces; Model - GE Appliances P2B930 Owner's Manual And Installation Instructions

The gasket is designed with a gap
at the bottom to allow for proper
air circulation.
Do not rub or clean the door
gasket-it has an extremely low
resistance to abrasion.
If you notice the gasket becoming
worn, frayed or damaged in any
way or if it has become displaced
on the door, you should have it
replaced.
Cleaning the Door
To clean the inside of the door:
Do not allow excess water to run into any
holes or slots in the door.
', Wipe dish washing detergent over any
baked-on splutters on the glass. Use a single
sided safety razor blade to clean it off. Then
wipe over the glass with a soapy cloth to
remove any residue and dry off.
The area outside the gasket can be cleaned
with a soup-filled plastic scouring pad.
GEAppliances.com
To clean the outside of the door'.
Use soap and water to thoroughly clean the
top, sides and front of the oven door. Rinse
well. You may also use a glass cleaner to
clean the glass on the outside
of the door.
Spillage of marinades, fruit juices, tomato
sauces and basting materials containing
acids may cause discoloration and should be
wiped up immediately. When the surface is
cool, clean and rinse.
Do not use oven cleaners, cleansing powders
or harsh abrasives on the
outside of the door.
Stainless Steel Surfaces (on some models)
Do not use a steel wool pad; it will scratch the
surface.
This will help you to maintain the brightness
and appearance of your stainless steel range.
In order to avoid any discolorations and/or
grease stains, we recommend cleaning and
removing any spills,spots and grease from
the range after use.
It is important to use a soft cloth or paper
towel every time the range is cleaned to
avoid any scratches.
Readcarefully the instructions on the back of
the Brightener for better results.
Cleaning Instructions:
2.. Removegrates.
2. Wash using warm, soapy water:
Wet soft cloth or paper towel (avoid using
excessive water).
Wipe the surface in the direction of the grain
(following the steel lines).
Rinseand wring out a soft cloth or paper
towel and dry the range.
& Apply a degreaser that does not contain
sodium hydroxide or stainless steel cleaner
(follow instructions).
4. Repeat steps 2-/4 as many times as needed.
5. Put grates back in place.
Follow these instructions for any stainless steel
surface on your range.
DO NOT USEfor cooktop or stainless steel
parts cleaning:
* Caustic lye (sodium hydroxide) or cleaners
containing this chemical
* Hard or steel wool pads
* Abrasive materials or chemicals
To inquire about purchasing stainless steel
appliance cleaner or polish, or to find the
location of a dealer nearest you, please call our
toll-free number:
National Parts Center 800.626.2002(U.S.)
800.662..2.62.5 (Canada)
GEApplianceParts.com (U.S.)
www.GEAppliances.ca (Canada)
35