Painted Surfaces; Stainless Steel Surfaces; Control Panel; Floor - GE JGS968 Owner's Manual

Gas slide-in ranges
Hide thumbs Also See for JGS968:
Table of Contents

Advertisement

Available languages

Available languages

Stainless Steel Surfaces

Do not use a steel-wool pad; it will
scratch the surface.
NOTE: If a mineral oil-based stainless steel
appliance cleaner has been used before
to clean the appliance, wash the surface

Painted Surfaces

Painted surfaces include the top and
sides of the door, and the drawer front.
Clean these with soap and water or
a vinegar and water solution.
Oven Vent
The oven is vented through an opening
in the cooktop under the grille.
Never cover the opening with aluminum
Center vent
foil or any other material. This would

Control Panel

If desired, the touch pads may be turned off
before cleaning.
See the Control Lockout section.
Clean up splatters with a damp cloth.
Removable Oven Floor
Oven floor
To remove the oven floor for easier
cleaning:
Shake bottle well.
Place a small amount of Stainless
Steel Appliance Cleaner on a damp
cloth or damp paper towel.
Clean a small area (approximately
8" x 8" [20.3 cm x 20.3 cm]),
rubbing with the grain of the
stainless steel if applicable.
Dry and buff with a clean, dry paper
towel or soft cloth.
Repeat as necessary.
Remove the oven door using the
instructions in the Lift-Off Oven Door
section.
Grasp oven floor at the rear finger
slots on each side, lift it up, push it
back and pull it out.
www.GEAppliances.ca (Canada)
with dishwashing liquid and water prior
to using the Stainless Steel Appliance
Cleaner. After washing the surface with
dishwashing liquid and water, use a
generous amount of Stainless Steel
Appliance Cleaner to clean the appliance.
To Order
To order Stainless Steel Appliance
Cleaner, please call our toll-free number:
National Parts
Center . . . . . . . . . . . . . . . 800.626.2002 (U.S.)
800.661.1616 (Canada)
ge.com (U.S.)
www.GEAppliances.ca (Canada)
Stainless Steel Appliance
Cleaner . . . . . . . . . . . . . . . . . . . .# PM10X311
Do not use commercial oven cleaners,
cleaning powders, steel wool or harsh
abrasives on any painted surface.
prevent the oven vent from working
properly.
You may also use a glass cleaner.
Remove heavier soil with warm soapy
water. Do not use abrasives of any kind.
Turn on the touch pads after cleaning.
Clean the oven floor with warm
soapy water.
IMPORTANT: Always replace the
removable floor before the next use.
ge.com (U.S.)
35

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents