Table of Contents
Advertisement
Finishing Around the Fireplace
Combustible mantels and mouldings may be safely installed over the
top and on the front of the fireplace provided that they do not project
beyond shaded area shown in Figure 27.
Fireplace Facing
When sizing the finish material for your fireplace, it is important to
remember the following: THE OPENING MUST NOT BE OBSTRUCTED
IN ANY WAY - to do so restricts the air supply for the control
compartments and heat exchanger it also prevents access for
servicing controls.
The face of the fireplace may be painted to match the room decor,
provided you use a heat-resistant paint. Decorative facing must not
extend past the fireplace opening at all, because it will interfere with
the access to retainers for removal of glass door.
Combustible surrounds may be installed with 3" clearance to the side
of the fireplace as shown in Figure 27a.
Horizontal Run (in)
Figure 27. Combustible mantels and facings.
Figure 27a. Combustible surrounds.
XG0140 - 120611.1
Installation
We recommend careful consideration be given to the effects of
elevated mantel temperatures which may be in excess of product
design, for example: candles, plastic or pictures. This can cause
melting, deformation, discolouration or premature failure of T.V.
radio, and other electronic components.
Do not attempt to clean glass when hot.
Do not clean glass with abrasive materials as any glass etching
may cause premature glass failure.
DO NOT OPERATE THIS FIREPLACE WITHOUT THE GLASS
Combustible
Construction allowed
in shaded area
Combustible Facing
Material
Combustible Framing
Material
Top of fireplace
3"
H-Series DL Gas Fireplace
WARNING!
WARNING!
CAUTION!
DOOR OR WITH A BROKEN GLASS DOOR.
Page 21
Hide quick links:
Advertisement
Table of Contents
