Marantz SR5006 Owner's Manual page 89

Surr.Parameter
Adjust surround sound parameters. It may not be possible to set this item depending on the input signal
(vpage 126 "Surround modes and surround parameters").
NOTE
• You cannot set the surround parameters in the PURE DIRECT mode.
• During playback in PURE DIRECT mode, the surround parameters are the same as in DIRECT mode.
Setting items
HT-EQ ON : "HT-EQ" is used.
Soften the treble range OFF : "HT-EQ" is not used.
of movie soundtracks for
better understanding.
Buttons on the remote control unit can be used
for operations.
AMP
q Press
AMP-operation mode.
HT-EQ
w Press
DRC Auto : Automatic dynamic range compression on/off control according to
Compress dynamic range source. This can be set in the Dolby TrueHD mode.
(difference between loud Low / Middle / High : These set the compression level.
and soft sounds). OFF : Dynamic range compression always off.
D.Comp OFF : Turn dynamic range compression off.
Compress dynamic range Low / Middle / High : These set the compression level.
(difference between loud
and soft sounds).
LFE –10dB – 0dB
Adjust the low-frequency
For proper playback of the different sources, we recommend setting
effects level (LFE).
to the values below.
• Dolby Digital sources : "0dB"
• DTS movie sources : "0dB"
• DTS music sources : "–10dB"
C.Image 0.0 – 1.0 (0.3)
Assign center channel
signal to front left and right
channels for wider sound.
Panorama ON : Set.
Assign front L/R signal also OFF : Do not set.
to surround channels for
wider sound.
BD
Default settings are underlined.
Setting details
to set the remote control unit to
.
Setting items
Dimension 0 – 6 (3)
Shift sound image center
to front or rear to adjust
playback balance.
C.Width 0 – 7 (3)
Assign center channel
signal to front left and right
channels for wider sound.
Low : Reduce the front height channel volume.
Height Gain
Control the front height Middle : Front height channel sound is output with standard sound
channel volume. volume.
High : Increase the front height channel volume.
NOTE
"Height Gain" is displayed for the following settings.
• When "Amp Assign" (vpage 92) is set to "F.HEIGHT".
• When the "Speaker Config." – "F.Height" setting
other than to "None".
• When surround mode is "PLgz" or the PLgz decoder is used.
Default Yes : Reset to the defaults.
The "Surr.Parameter" No : Do not reset to the defaults.
settings are returned to the
When you select "Default" and press
default settings.
the "Return settings to the default?" prompt
is displayed. Select either "Yes" or "No", and
press
86
Setting details
(vpage
ENTER
,
ENTER
.
Audio Adjust
93) is set