Marantz SR5006 Owner's Manual page 105

Setting items
GUI Screensaver : Make screensaver settings.
Make the settings related to • ON : The screensaver is activated during
displays on the TV screen. menu display, NET/USB, iPod or Tuner screen
display if no operation is performed for an
approximately 5-minute continuous period.
When you press
cancelled and the screen before that screen
saver started is displayed.
• OFF : Screensaver is not activated.
Format : Set the video signal format to be output for the TV you are using.
• NTSC : Select NTSC output.
• PAL : Select PAL output.
"Format" can also be set by the following procedure. However, the menu
screen is not displayed.
1. Press and hold the main unit's
seconds.
"Video Format" appears on the display.
2. Press the main unit's
the video signal format.
3. Press the main unit's
NOTE
When a format other than the video format of the connected TV is set, the
picture will not be displayed properly.
Text : Display the details of operation when switching surround mode,
input mode, etc.
• ON : Turn display on.
• OFF : Turn display off.
Master Volume : Display the master volume during adjustment.
• Bottom : Display at the bottom.
• Top : Display at the top.
• OFF : Turn display off.
When the master volume display is hard to see when superimposed
on movie subtitles, set to "Top".
BD
Setting details
uio p
, the screensaver is
ZONE SELECT STATUS
and for at least 3
INTERNET RADIO ONE TOUCH PLAY
or
PURE DIRECT
to complete the setting.
Setting items
GUI NET/USB : Set the NET/USB screen display time when the input source
(Continued) is "NET/USB".
• Always : Show display continuously.
• 30s : Show display for 30 seconds after operation.
• 10s : Show display for 10 seconds after operation.
• OFF : Turn display off.
iPod : Set the iPod screen display time when the input source is
"USB/iPod".
• Always : Show display continuously.
• 30s : Show display for 30 seconds after operation.
• 10s : Show display for 10 seconds after operation.
• OFF : Turn display off.
Tuner : Set the tuner screen display time when the input source is
"TUNER".
• Always : Show display continuously.
• 30s : Show display for 30 seconds after operation.
• 10s : Show display for 10 seconds after operation.
• OFF : Turn display off.
Zone Rename • Up to 10 characters can be input.
and set
Change the display title of • For character input, see page 83.
each zone to one you prefer.
ON : Display is always on.
Display
Set the display on/off Auto OFF : Display is off except when showing the status display.
setting. OFF : Display is always off.
• This can also be set by pressing
• If
102
Setting details
DISP
.
DISP
Each time is pressed, the setting is changed as shown below.
ON Auto Off
OFF
DISPLAY
on the main unit is pressed, the
same function as with the remote control unit
can be obtained.
System Setup
vSee overleaf