•
Select "ALL" Fleet and "ALL" ID to make a call to all units
STATUS MESSAGE
be decided in your talk group. Messages can contain up to 16
memory of your transceiver.
Transmitting
1 Select your desired zone and channel.
2 Press the key programmed as Status to enter Status
3 Press
•
If Manual Dialing is enabled, you can enter a station ID
by using the DTMF keypad, or by using
using
then press
right. Repeat this process until the entire ID is entered.
4 Press
5 Press
•
If Manual Dialing is enabled, you can enter a status ID by
using the DTMF keypad, or by using
6 Press the PTT
has been successfully transmitted.
, cycle through the digits to select a digit,
to set the digit and move the cursor to the
to enter Status mode.
Selcall + Status to enter
Side 2 key to initiate the call.
. When
21