Temporary Channel Lockout; Priority Scan - Kenwood NEXEDGE NX-200 Instruction Manual

Scan monitors for signals on the transceiver channels. While
scanning, the transceiver checks for a signal on each channel
and only stops if a signal is present.
To begin scanning, press the key programmed as Scan.
• The
• When a signal is detected on a channel, Scan pauses at that
To stop scanning, press the Scan key again.
Note: To use Scan, there must be at least 2 channels in the scan
sequence.

TEMPORARY CHANNEL LOCKOUT

from the scanning sequence by selecting them and pressing
the key programmed as Scan Delete/Add.
ended and restarted, the channels are reset and deleted channels

PRIORITY SCAN

Note: To use Priority Scan, a Priority channel must be programmed.
received on that channel, even if a call is being received on a
normal channel.
When using dual Priority channels, Priority channel 1 is given
precedence over Priority channel 2. So, if a call is received on
SCAN