Table of Contents
Advertisement
Assembly
Installing a Tool Attachment
1. Place the Multipurpose Tool Carrier (A) and the Tool Assembly (B) on a clean,
flat surface so that both assemblies fit end to end. The powerhead assembly
should be facing up, and the tool assembly should be positioned with the lock-
ing hole in the tube (C) end facing up.
CAUTION!
Keep the open ends of the tubes clean and free of Debris!
2. Slip off the protective cover from the end of the tool, and loosen the coupler
screw knob (D).
3. Insert the tool assembly into the coupler (E), with the tool decal facing up, until
the line of the decal is flush with the end of the coupler. Twist the tool back and
forth until you are sure it snaps in place by the coupler latch (F).
4. When the two tube halves are locked together, press down on the spring-load-
ed latch protector (G) and tighten the coupler screw knob.
Removing a Tool Attachment
1. Place the Multipurpose Tool Carrier and the Tool Assembly on a clean, flat sur-
face, loosen the coupler screw knob (D). The spring-loaded coupler protector
(G) should pop up.
2. Press down on the latch (F) with your finger or thumb. This releases the cou-
pler latch.
3. Pull the tool assembly (B) out of the coupler (E).
6
A
G
F
M23004
D
E
E
G
M23005
D
M23006
C
B
Advertisement
Table of Contents
