Assembly - Shindaiwa 81714 Owner's/Operator's Manual

Assembly

Cutting Attachment Shield
Socket-
Head Cap
Screw
Shim
Clamp
Screw
Retaining
Nut
Figure 9
Install the Cutting Attachment Shield
C3410.
1. Insert the cutting attachment shield
between the outer tube and the cutting
attachment mounting plate.
See Figure 9.
NOTE:
It may be necessary to loosen the retaining
nut and clamp screw to adjust cutting attach-
ment shield mounting plate.
. Fit the two shims and the bracket over
the outer tube and loosely install the
four socket-head screws. See Figure 9.
3. Tighten the four socket-head cap screws
to secure the cutting attachment shield.
CAUTION!
Make sure the clamp screw and
retaining nut are securely tightened
before tightening the four socket-head
cap screws.
6
6
Bracket
Outer
Tube
Shim
Cutting
Cutting
Attachment Mounting
Attachment
Plate
Shield
NEVER operate the unit without the
cutting attachment shield installed
and tightly secured!
Sub-Shield C3410.
(when trimmer head is in use)
1. Attach the shield extension to the
cutting attachment shield. See figure 9B.
NEVER use this machine without sub-
shield when using a trimmer head.
WARNING!
WARNING!
Cutting Attachment Shield
Line Cutter
Figure 9A
Cutting Attachment Shield
Hook
Receiver
Sub-shield
Figure 9B
CAUTION!
Make sure the sub-guard is
completely hooked at the hook
receiver.
Sub-shield
with Line
Hook