Seagate SCSI Interface Product Manual page 267

SCSI Interface Product Manual, Rev. J
request 6, 7
confirmation transaction 6
response transaction 6
SCSI bus signal 12
request sense 20, 45, 46, 144, 209
Request Sense command 43, 67, 68, 70, 102,
175, 191, 192, 199, 200, 221
rescind reservation 201
reselection 127
reselection phase 19
reselection procedure 20
resend message 41
reservation 165, 187, 200, 201
reservation access conflict 213, 219
reservation conflict 157
reservation conflict status 48, 153, 159, 162, 171,
200, 213, 219
reservation descriptor 156
Reservation Identification
Release (10) command 188
Release (6) command 187
Reserve (10) command 202
Reserve (6) command 200
reservation identification byte 187
Reservation Key
Persistent Reserve Out parameter list 159
Read Reservations Descriptor 156
reservation key 154, 159, 160
Reservation Key List
Persistent Reserve In parameter data 154, 155
reservation process 201
reservation protocol 201
Reservations Descriptor
Persistent Reserve In parameter data 155
Reserve
Service Action code 159
reserve 209
Reserve (10) command 202
Reserve (6) command 200
Reserve command 48, 72, 158, 200, 201
reserve service action 154, 155, 159, 160
reserved 8
Reserved Area
Translate Address page—Receive Diagnostic
183, 184
reserved bit 43
reserved byte 43
reserved code value 43
reserved fields 43
reserved nonuser-accessible cylinder 206
reset 144, 217
command 213
condition 23, 24, 162
event 6
hard 4
hold time 15
message 144
SCSI bus signal 12
response 6
service 7
Response Data Format
Drive Standard Inquiry Data 88, 89
restore pointers 31, 33, 41
restriction
signal 23
retry 124, 133
retry algorithm 108, 124
retry count field 194
retry mechanisms 133
retry message 41
retry phase 41
return all supported pages 115, 120, 150
Return Changeable values
Page Control Field bits 119
Return Current values
Page Control Field bits 119
Return Default values
Page Control Field bits 119
return defect list header 169, 170
Return Saved values
Page Control Field bits 119
Rezero Unit command 203
rigid drive geometry page descriptor 122
rigid drive geometry parameters 115, 120, 150
page 130
RLEC. see Report Log Exception Condition
RMB
Format Parameters page 128
ROM release date 96
Rotational Offset
Rigid Drive Geometry Parameters page 130,
131
Rotational Position Locking
Rigid Drive Geometry Parameters page 130,
131
rotational position locking 131
Round
Unit Attention Parameters page 144
round down 138
rounded parameter 72, 144
rounding 113, 117
rounding of parameter values 72
RPL. see Rotational Position Locking
RST. see Reset
S
S.M.A.R.T. see Self-Monitoring Analysis and
Reporting Technology
SAM-compliant target identifier 180, 226
SAP. see Servo Adaptive Parameters
savable parameter 112
Save
Change Definition command 78
Save Control
Change Definition command 78
253