Seagate SCSI Interface Product Manual page 211

SCSI Interface Product Manual, Rev. J
Table 157: Error codes for bytes 12 and 13 of Sense Data (values are in hexadecimal) (continued)
Byte Byte
12 13 Description
17 03 Recovered Data Using Negative Offset
17 05 Recovered Data Using Previous Logical Block ID
17 06 Recovered Data Without ECC—Data Auto Reallocated
18 00 Recovered Data With ECC
18 01 Recovered Data With ECC And Retries Applied
18 02 Recovered Data With ECC And/Or Retries, Data Auto-Reallocated
18 05 Recovered Data—Recommand Reassignment
18 07 Recovered Data With ECC—Data Rewritten
19 00 Defect List Error
19 01 Defect List Not Available
19 02 Defect List Error In Primary List
19 03 Defect List Error in Grown List
1A 00 Parameter List Length Error
1B 00 Synchronous Data Transfer Error
1C 00 Defect List Not Found
1C 01 Primary Defect List Not Found
1C 02 Grown Defect List Not Found
1C 83 Seagate Unique Diagnostic Code
1D 00 Miscompare During Verify Operation
20 00 Invalid Command Operation Code
21 00 Logical Block Address Out Of Range
24 00 Invalid Field In CDB
25 00 Logical Unit Not Supported
26 00 Invalid Field In Parameter List
26 01 Parameter Not Supported
26 02 Parameter Value Invalid
26 03 Invalid Field Parameter—Threshold Parameter
26 98 Invalid Field Parameter—Check Sum
26 99 Invalid Field Parameter—Firmware Tag
27 00 Write Protected
29 00 Power On, Reset, Or Bus Device Reset Occurred
29 01 Power-On Reset Occurred
29 02 SCSI Bus Reset Occurred
29 03 Bus Device Reset Function Occurred
29 04 Device Internal Reset Occurred
29 05 Transceiver Mode Changed To Single-Ended
29 06 Transceiver Mode Changed To LVD
2A 01 Mode Parameters Changed
2A 02 Log Parameters Changed
2A 03 Reservations preempted
197