Seagate SCSI Interface Product Manual page 212

198
Table 157: Error codes for bytes 12 and 13 of Sense Data (values are in hexadecimal) (continued)
Byte Byte
12 13 Description
2C 00 Command Sequence Error
2F 00 Tagged Commands Cleared By Another Initiator
31 00 Medium Format Corrupted
31 01 Format Failed
31 91 Format Corrupted, World Wide Name (WWN) Is Invalid
32 00 No Defect Spare Location Available
32 01 Defect list update Error
32 02 No Spares Available—Too Many Defects On One Track
37 00 Parameter Rounded
3D 00 Invalid Bits In Identify Message
3E 00 Logical Unit Has Not Self Configured Yet
3F 00 Target Operating Conditions Have Changed
3F 01 Microcode Changed
3F 02 Changed Operating Definition
3F 90 Invalid APM Parameters
3F 91 World Wide Name (WWN) Mismatch
40 01 DRAM Parity Error
42 00 Power-On Or Self-Test Failure
43 00 Message Error
44 00 Internal Target Failure
45 00 Select/Reselection Failure
47 00 SCSI Parity Error
48 00 Initiator Detected Error Message Received
49 00 Invalid Message Error
4C 00 Logical Unit Failed Self-Configuration
4E 00 Overlapped Commands Attempted
*
00 Log Exception
5B
5B* 01 Threshold Condition Met
5B* 02 Log Counter At Maximum
5B* 03 Log List Codes Exhausted
5C 00 RPL Status Change
5C 01 Spindles Synchronized
5C 02 Spindles Not Synchronized
5D 00 Failure Prediction Threshold Exceeded
65 00 Voltage Fault
80 00 General Firmware Error Qualifier
81 00 Reassign Power—Fail Recovery Failed
* Can be supported, but is a factory installed option.
SCSI Interface Product Manual, Rev. J